# Print settings for Slic3r Prusa Edition     
Select the "0.20mm NORMAL" setting that comes with Slic3r and change the following parameters:    
ensure_vertical_shell_thickness = 0     
fill_density = 5%    
first_layer_height = 0.3    
perimeters = 1    
thin_walls = 1    

# Print settings for Cura 4.x    
Select the Draft 0.2mm profile and change build plate adhesion to skirt.  
For the N64 sleeve you need to enable the special mode "Spiralize outer Contour" or else the walls will be too thick.  

# Combined STL file with all parts      

![image](https://dl.dropboxusercontent.com/s/zbrvq9lf6w6ye3l/combined.png?dl=1)   

# Separate STL files for each part    

#### snes_spacer.stl is a small 3d printed spacer to relieve pressure from the pins of SNES clone console slot   

![image](https://dl.dropboxusercontent.com/s/07slhy8pi9ujiri/snes_spacer.png?dl=1)   

#### n64sleeve.stl helps with aligning N64 cartridges if the clone slot is not long/wide enough   
![image](https://dl.dropboxusercontent.com/s/s6jxobazww3sm81/n64sleeve.png?dl=1)   

#### backplate_tabs.stl is the backplate that holds the Arduino    

![image](https://dl.dropboxusercontent.com/s/01v4d28lzbp1ue4/backplate16.png?dl=1)    

#### sd_spacer.stl or microsd_spacer hold the RGB led and fit between the SD card and the Cart Reader pcb (print with clear PLA/ABS)    

![image](https://dl.dropboxusercontent.com/s/2nujdtcrzvrh7hg/sd_spacer.png?dl=1)  

#### sidewall_tabs.stl secures the Arduino Mega to the backplate with five M2x8 screws    

![image](https://dl.dropboxusercontent.com/s/p7v2l37f1c130b4/sidewall.png?dl=1)  

#### case_xxx.stl are a replacement for the more simple backplate in case you prefer a full enclosure   

![image](https://dl.dropboxusercontent.com/s/lzgrrkm5yfflll9/v17_case2.png?dl=1) 

#### The rest of the STL files are alternative designs in case you use the battery add-on.