mirror of
https://github.com/sanni/cartreader.git
synced 2024-11-13 08:25:05 +01:00
| .. | ||
| backplate_simple_battery.stl | ||
| backplate_simple.stl | ||
| case_bottom_battery.stl | ||
| case_bottom.stl | ||
| case_button_3mm.stl | ||
| case_top_battery.stl | ||
| case_top.stl | ||
| combined.stl | ||
| microsd_spacer.stl | ||
| n64sleeve.stl | ||
| README.md | ||
| sidewall_battery.stl | ||
| sidewall_tabs.stl | ||
| snes_spacer.stl | ||
Print settings for Slic3r Prusa Edition
Select the "0.20mm NORMAL" setting that comes with Slic3r and change the following parameters:
ensure_vertical_shell_thickness = 0
fill_density = 5%
first_layer_height = 0.3
perimeters = 1
thin_walls = 1
Print settings for Cura 4.x
You can use the Draft 0.2mm profile but you might want to change the build plate adhesion settings since the default seems a bit too much.
For the N64 sleeve you need to enable the special mode "Spiralize outer Contour" or else the walls might end up too thick.
Combined STL file with all parts
combined.stl has all the needed parts combined into one STL file in case you use a 3D print service that calculates by volume.
Separate STL files for each part
snes_spacer.stl is a small 3d printed spacer to relieve pressure from the pins of SNES clone console slot
n64sleeve.stl helps with aligning N64 cartridges
backplate_simple.stl is the backplate that holds the Arduino
microsd_spacer holds the RGB led and fits between the micro SD card and the Cart Reader pcb (print with clear PLA)
sidewall_tabs.stl secures the Arduino Mega to the backplate with five M2x8 screws
Full enclosure addon
The case_xxx.stl files are a replacement for backplate_simple.stl in case you prefer a full enclosure, you will still need the other stls though.
