- Note [1]: Flash memory region `0x04E0_0000` - `0x04FD_FFFF` is write protected as it contains N64 bootloader. This section can be overwritten only via firmware update process.
- Note [2]: Due to BlockRAM usage optimization this section is read only.
- Note [3]: Read returns `0`. Maximum accessibe address space is 128 MiB.
- Note [1]: 64DD IPL share SDRAM memory space with ROM (last 4 MiB minus 128 kiB for saves). Write access is always disabled for this section.
- Note [2]: SRAM and FlashRAM save types share SDRAM memory space with ROM (last 128 kiB).
- Note [3]: 32 kiB chunks are accesed at `0x0800_0000`, `0x0804_0000` and `0x0808_0000`.
- Note [4]: FlashRAM read access is multiplexed between mem and reg bus, writes are always mapped to reg bus.
- Note [5]: Write access is available when `ROM_WRITE_ENABLE` config is enabled.
- Note [6]: This address overlaps last 128 kiB of ROM space allowing SRAM and FlashRAM save types to work with games occupying almost all of ROM space (for example Pokemon Stadium 2). Reads are redirected to last 128 kiB of flash.
- Note [7]: Always accessible regardless of ROM shadow switch.
- Note [8]: Used internally and exposed only for debugging.
### Address decoding limitations
Current implementation of PI interface checks only upper 16 bits of address. Bus and device are chosen only from value of starting address.
In specific situations this could lead to unexpected behavior when performing R/W operations crossing 64 kiB boundaries.
Page size (as called by N64 docs) is configurable by `PI_BSD_DOMn_PGS` register. Maximum page size can be set up to 128 kiB blocks.
PI controller inside N64 will automatically reissue address at set boundary when performing R/W operation that crosses it.
For example, setting largest page size then doing 128 kiB read starting from address `0x1FFE_0000` will select *mem bus* and start fetching data from mapped internal address `0x0500_0000`.
SC64 registers are available at base address `0x1FFF_0000` (`0x1FFE_0000` + 64 kiB), but are connected to *reg bus*.
As a consequence of this design data read by N64 in single transaction will not contain values of SC64 registers at 64 kiB offset.
1. Check if command is already executing by reading `CMD_BUSY` bit in **STATUS/COMMAND** register (optional).
2. Write command argument values to **DATA0** and **DATA1** registers, can be skipped if command doesn't require it.
3. Write command ID to **STATUS/COMMAND** register.
4. Wait for `CMD_BUSY` bit in **STATUS/COMMAND** register to go low.
5. Check if `CMD_ERROR` bit in **STATUS/COMMAND** is set:
- If error is set then read **DATA0** register containing error code.
- If error is not set then read **DATA0** and **DATA1** registers containing command result values, can be skipped if command doesn't return any values.
