mirror of
https://github.com/sanni/cartreader.git
synced 2024-12-11 21:54:17 +01:00
48 lines
2.2 KiB
Markdown
48 lines
2.2 KiB
Markdown
# Print settings for Slic3r Prusa Edition
|
|
Select the "0.20mm NORMAL" setting that comes with Slic3r and change the following parameters:
|
|
ensure_vertical_shell_thickness = 0
|
|
fill_density = 5%
|
|
first_layer_height = 0.3
|
|
perimeters = 1
|
|
thin_walls = 1
|
|
|
|
# Print settings for Cura 4.x
|
|
You can use the Draft 0.2mm profile but you might want to change the build plate adhesion settings since the default seems a bit [too much](https://www.dropbox.com/s/qu8fvjsh33bxjeh/curaprint.jpg?dl=0).
|
|
For the N64 sleeve you need to enable the special mode "Spiralize outer Contour" or else the walls might end up too thick.
|
|
|
|
# Combined STL file with all parts
|
|
#### combined.stl has all the needed parts combined into one STL file in case you use a 3D print service that calculates by volume.
|
|
|
|
![image](https://dl.dropboxusercontent.com/s/zbrvq9lf6w6ye3l/combined.png?dl=1)
|
|
|
|
# Separate STL files for each part
|
|
|
|
#### snes_spacer.stl is a small 3d printed spacer to relieve pressure from the pins of SNES clone console slot
|
|
|
|
![image](https://dl.dropboxusercontent.com/s/07slhy8pi9ujiri/snes_spacer.png?dl=1)
|
|
|
|
#### n64sleeve.stl helps with aligning N64 cartridges
|
|
![image](https://dl.dropboxusercontent.com/s/8muv7x1fiz2n169/n64sleeve.png?dl=1)
|
|
|
|
#### backplate_simple.stl is the backplate that holds the Arduino
|
|
|
|
![image](https://dl.dropboxusercontent.com/s/10pbg2umbp6ylv5/backplate_simple.png?dl=1)
|
|
|
|
#### microsd_spacer holds the RGB led and fits between the micro SD card and the Cart Reader pcb (print with clear PLA)
|
|
|
|
![image](https://dl.dropboxusercontent.com/s/ch045dkev7al9v7/msdspacer.png?dl=1)
|
|
|
|
#### sidewall_tabs.stl secures the Arduino Mega to the backplate with five M2x8 screws
|
|
|
|
![image](https://dl.dropboxusercontent.com/s/p7v2l37f1c130b4/sidewall.png?dl=1)
|
|
|
|
# Full enclosure addon
|
|
|
|
#### The case_xxx.stl files are a replacement for backplate_simple.stl in case you prefer a full enclosure, you will still need the other stls though.
|
|
|
|
![image](https://dl.dropboxusercontent.com/s/lzgrrkm5yfflll9/v17_case2.png?dl=1)
|
|
|
|
# Battery addon
|
|
|
|
#### The xxx_battery.stl files are alternative designs in case you use the battery add-on and replace the similary named default stls.
|